Segway A200 E-Bike - Rear Sensor Of The Cable Lock Repair Video
How to replace the rear sensor of the cable lock
Tool preparation: T20 bit, T25bit, corner turner, electric screwdriver Part 1: Disassembly Power off the E bike, pull the cable lock out of the fender cover. Remove 2 screws M5*12 with T25 bit, pick up the top cover of the rear cover and disconnect the ware harness of the sensor, then take out the top cover. Remove the 4 screw ST4.2x13 with T20 bit, then remove the sensor and the cover plate.
Part 2: Assembly Take the new sensor, install it on the cover plate, and then buckle the sensor to the fender cover. Fasten 4 screws ST4.2x13 on the cover plate with T20 bit, Torque: 3-4N·m. Connect the wire harness of the sensor, install the top cover on the rear fender, be careful not the press the wire harness, and then fasten 1 screw ST4.2x13 with T20 bit, Torque: 3-4N·m. Insert the cable lock into the upper cover of the rear fender.
Prev: No Data ...
Running a fleet on this hardware?
Levy Fleets runs scooters, e-bikes, mopeds and golf carts on the IoT hardware you already have, with integration pages for 29 vendors including Segway, Okai, Omni, Queclink, Invers and Comodule. Keyless unlock, geofencing, rider payments and rider support are included, and the Managed plan is a share of revenue with no per-vehicle software fee.