Segway A200 E-Bike - Lock Cable Repair Video

How to replace the lock cable

Tool preparation: T20 bit, T25bit, corner turner, electric screwdriver Part 1: Disassembly Power off the E bike, pull the cable lock out of the fender cover. Remove the seat cushion anti-theft screw M58 with T20 bit and corner turner, open the seat tube clamp outwards, and then take out the seat tube and seat cushion upward. Remove 1 screws ST4.8x13 with T20 bit, pick up the top cover of the rear fender and disconnect the ware harness of the sensor, then take out the top cover. Remove the cable lock label, remove 2 screws M58 with T20 bit, then remove the side cover of the rear fender. Remove 1 screw M58 with T20 bit, then remove 5 screws on both sides of the fender with T25 bit. Then take out the rear fender upward. Remove 2 screws M510 with T20 bit, and take out the lock cable. Part 2: Assembly Arrange the wire harness and put them into the slot. Then install the new lock cable, fasten 2 screws M510 with T25 bit, Torque: 5-7N·m Install the fender on the frame, pay attention to pass the wire harness of the rear light and the sensor out of the corresponding wire hole of the fender, and move the rear fender support to align with the screw hole on the fender. Fasten 1 screw M58 with T20 bit, Torque: 4-5N·m, then fasten 5 screws on both sides of the fender with T25 bit, Torque: 5-7N·m. Install the side cover of the rear fender, fasten 2 screws M58 with T20 bit, Torque: 5-7N·m, then install the cable lock label. Connect the wire harness of the rear light and the sensor, install the top cover on the rear fender, be careful not the press the wire harness, and then fasten 1 screw ST4.8x13 with T20 bit, Torque: 3-4N·m. Insert the seat tube and cushion into the frame, select the appropriate height, and then close the seat tube clamp inward. Tighten the seat cushion anti-theft screw M58 with T20 bit and corner device, Torque: 4-5N·m. Insert the cable lock into the upper cover of the rear fender.