Segway C80 E-Moped - Throttle And Right Status Light Repair Video
How to replace the throttle and right status light
Tool preparation: 2.7mm pentagonal bit, 3.95mm pentagonal bit, 5.45mm mm pentagonal bit, PH2 bit, H5 bit, Cable tie, Scissors/ Oblique pliers, Electric screwdriver Part 1: disassembly Pull out the panel along the edge with force. Remove 4 pentagonal screws ST4.212 with 3.95mm pentagonal bit, then pull out the cowl panel with force. Remove the cowl panel connector upwards and cut off the cable tie. Remove the winding tape and take down the wire harnesses, then disconnect the right status lamp harness, right combination switch harness and throttle harness respectively. Remove the 4screws with ST4.212 with 3.95mm pentagonal bit, remove 2 screws M612 with 5.45 mm pentagonal bit, then take out the back hidden line shell. Remove 2 screws ST4.29.5 with PH2 bit, then take out the front hidden line shell. Remove the screw M410 with 2.7mm pentagonal bit, then take out the right combination switch. Remove two screws M612 with H5 bit and remove the splint, then remove the brake assembly and status light from the handlebar. Remove 1 screw M310 with PH2 bit and the take out the throttle from the brake assembly. Remove 1 screw M48 with PH2 bit and take out the right status lamp from the brake assembly. Part 2: assembly Take the new status light and new throttle, and install the status light on the brake assembly, fasten 1 screw M48 with PH2 bit, Torque: 2.7-4N·m. Install the throttle and fasten 1 screw M310 with PH2 bit, Torque: 0.8-1.2N·m. Then put the brake assembly to the handlebar. Arrange the throttle harness and press it into the cable slot. The install the clamp plate, pay attention to the clamp plate positioning hook into the handlebar positioning hole, tighten two M612 screws with H5 bit, Torque: 7-11N·m Install the right combination switch, buckle it in place, and the gap is less than 1mm. Pay attention to wiring from the slot of combination switch and brake handle assembly to avoid extrusion. Then fasten one screw M410 with PH2 bit, Torque: 2.7-4N·m. Connect throttle harness, status lamp harness and combination switch harness respectively. Arrange the wiring harness and install the cable tie. Install the front hidden wire shell. Pay attention to place the harness into the hidden wire shell, and fasten two screws ST4.29.5 with PH2 bit, Torque: 1.9-2.7 N·m. Install the back hidden wire shell, the hidden wire shell should be buckled in place, fasten two pentagonal screws M614 with 5.45mm pentagonal bit, Torque: 7-11N·m. Then fasten 4 pentagonal screws st4.212 with 3.95mm pentagonal bit, Torque: 1.9-2.7N·m Arrange the wiring harness and install the winding tape, then fix the wire harness with the harness clamp. and install the cowl panel connector. Attach the edge panel to the frame, Pay attention to the alignment of the clip slot. Then fasten 4 pentagonal screws ST4.212 with 3.95mm pentagonal bit, and Torque: 1.9-2.7N·m. Install the front plate, and align to the clamping slot and make it fully engaged