Segway C80 E-Moped - Rear Light Repair Video
How to replace the rear light
Tool preparation:10mm socket wrench, PH2 bit, mobile phone, Electric screwdriver, needle nose pliers Part 1: disassembly Remove the seat bucket and cushion Opens the cushion with APP, disconnects the battery cable and takes out the battery. Take out and disconnect the sensing harness connection. Tear off the note paper, remove 2 screws st4.213 with PH2 bit, lift the right side of the outlet cover, and take down one screw M612 at the side with PH2 bit. Pull up the handle of the stem lock, take out the round head of the stem lock from the groove of the handle, take down the handle, and then take out the outlet cover. Remove 4 M616 flange bolts with 10mm socket wrench, and take out the seat bucket and cushion assembly upward. Remove the rear light Disconnect the rear light wire harness: red brown blue and yellow brown blue yellow green, remove 2 screws M612 with PH2 bit, pull the rear light harness out of the round hole, and remove the rear light Part 2: assembly Install the rear light Pass the rear light harness through the rear inner fender mounting hole, pay attention to the rear light direction, narrow up and wide down. Then align the screw holes, and fasten two screws M612 with PH2 bit, Torque: 7-11N·m, then connect the harness. Install the sear barrel and cushion Install the seat barrel and cushion assembly into the frame, pay attention to passing the gravity induction harness, battery harness and stem lock through the corresponding wire holes. Install the seat barrel in place, install four M616 flange bolts, and fasten them with the 10mm socket wrench, Torque: 9.8-14N·m. Install the outlet cover, and the lock handle of the stem shall pass through the round hole in the middle of the outlet cover. Align the screw hole of the fixing plate of the tap lock with the outlet screw hole on the side, then fasten 1 screw M612 with PH2 bit, Torque: 7-11N·m. Install the stem lock handle, clip the lock handle of the stem into the lock handle of the stem, press the outlet cover, press and hold the lock and lift the handle upward, so that the cylinder head of the lock can clip into the groove of the handle, and press the handle downward, so that the block head under the handle can fully clip into the outlet cover. Clip the battery harness into the wire slot, align the screw hole of the outlet cover with the screw diagram of the base barrel, fasten two st4.213 screws with PH2 bit, Torque: 1.9-2.7N·m, and paste a new label. Install the battery, pay attention to the direction of the battery, the arrow is in front, "ninebot" is in the rear and insert the battery terminal. Connect the gravity sensing harness terminal and clip it into the cable slot, close and lock the cushion.