Segway Max Pro (2.2) Electric Scooter - Tube Protector Repair Video

How to replace the collar clamp?Tool preparation Torque screwdriver, T25 bit, T30 bit, new collar clamp(tube protector) Remove the stem Remove 1 M510 screw on the front side of the front tube with T25. Remove 2 M720 screws on the back side of the front tube with T30. Pull out the stem, disconnect the connection of control bus, Remove the black plate cover of the brake box, Take the brake cable plastic connector from the groove of the brake box, Brake cable pass through the open slot of front tube, Remove the brake cable connector from the brake cable box, then take off the stem. Remove the collar clamp Remove 1 M620 screw on the front tube with the T30 and take out the collar clamp. Install the collar clamp Install the collar clamp on the front tube. Align screw holes, and then tighten the front side screw M620 with the T30 bit, Torque:5-7N·m. Install the stem Insert the brake cable from the open slot of front tube, insert the other end of the cable into the brake box, The brake cable plastic connector is installed in the groove of the brake wire box, Install plate cover of the brake box. Connect the control bus and insert the stem into the front tube. Tighten 2 M720 screws with T30, Torque: 9-12N·m. Tighten 1 M510 screw with T25, Torque: 5-6N·m Function detection Power on the scooter, and confirm that it functions properly