Segway Max Pro (2.2) Electric Scooter - Tube Assembly Repair Video

How to replace the tube assemblyTool preparation Torque screwdriver, T25, T15, new tube assembly. Remove the stem assembly

Remove 2 M616 strews on the back side of the front tube with T30, Remove 1 M510 strew on the front side of the front tube with T25. Pull out the stem, disconnect the connection of control bus, Remove the black plate cover of the brake box, Brake wire pass through the open slot of front tube, Remove the brake wire end from the connection block of the brake cable box, then take off the stem. Remove the tube assembly

Remove 1 M620 screw on the front tube with the T30 and take out the Jacket. Remove the 3 M720 screws on the back side of the front tube, Lift the front tube up and remove the front tube Install new tube assembly

Install the front tube and Jacket on the front fork assembly, Align the riser hole with the riser adapter hole. Tighten 3 M720 screws on the back side of the front tube with the T30 bit, Torque: 9-12N·m, place the protection kit in place, and fasten 1 M620 screw on the front side of the front tube with T30 bit, Torque:5-7N·m Install the stem assembly Insert the brake wire from the open slot of front tube, insert the block at the end of the brake into the connecting block of the brake box, Install plate cover of the brake box. Connect the control bus and insert the stem into the front tube. Fasten 1 M510 screw with T25, Torque: 5-6N·m, Fasten 2 M720 screws with T30, Torque: 9-12N·m Function detection Power on the scooter, and c confirm that it functions properly