Segway E110L E-Moped - Footrest Trim、Middle Edgings And Front Edge Repair Video

How to replace the footrest trim, middle edgings and front edge

Tool preparation:5.45mm pentagonal bit, 3.95mm pentagonal bit, tweezers, PH2 bit, electric screwdriver Part 1: Disassembly Remove 2 rubber stopper on the upper part of the front windshield, then remove 2 screws ST4.212 with 3.95mm pentagonal bit, then slap the connection between the panel and the front windshield, and take out the panel. Press down and eject the left foot rest, remove 1 screw M6 * 12 with 5.45mm pentagonal bit, remove the left foot rest trim, and then fold up the left foot rest. Remove one screw ST4.214 with PH2 bit. Remove the 1 screw ST4.212 at the end of the left middle edge strip with 3.95mm pentagonal bit. Remove 2 rubber stoppers on left side of the pedal, then remove 2 screws ST4.212 with 3.95mm pentagonal bit. Remove the 3 screws ST4.212 under the left middle edge strip with 3.95mm pentagonal bit, and then remove the left middle edge strip and trim assembly. Remove the screw st4.2 * 14 on the left front wall edge strip with PH2 bit, push up and remove the right front wall edge strip. Then remove the right middle edge strip and trim assembly and the right wall edge strip in the same way. Remove the 2 clips, push down and remove the left trim strip, and remove the right trim strip in the same way. Part 2: Assembly Install the left trim strip on the middle edge strip, push inward and lock them together, then install 2 clips on the strip with the protruding end facing inward. And install right trim strip in the same way, Install the left front wall side strip buckle on the front windshield, align the snap and push down the front wall edge strip, align with the screw hole, and fasten the screw st4.214 with PH2 bit, Torque: 1.9-2.7N·m. Install the left side middle edge strip, fasten 2 screws st4.212 on the strip with 3.95mm pentagonal bit, Torque: 1.9-2.7N·m. Then tighten one cross screw st4.212 with PH2 bit, Torque: 1.9-2.7N·m. Fasten 4 screws st4.212 under the strip with 3.95mm pentagonal bit, Torque: 1.9-2.7N·m. Pop out the left foot rest, install the left foot rest trim, and fasten one screw M612 with 5.45mm Pentagram bit, Torque: 7-11N·m, then install 2 rubber plugs Install the right side middle edge strip and front wall side strip in the same way. Install the panel, buckle it to the front windshield, and fasten 2 pentagonal screws ST4.2*12 with 3.95mm pentagonal bit, Torque: 1.9-2.7N·M, and then install the rubber stopper