Segway E110L E-Moped - Charging Terminal Repair Video

How to replace the charging terminal

Tool preparation: Mobile phone, 2.7mm pentagonal bit, 5.45mm pentagonal bit, needle nose pliers, electric screwdriver Part 1: Disassembly Power off the moped, open the seat cushion with APP, then remove 4 screws with 5.45mm inner Pentagon anti-theft bit Put down the seat cushion gently, taking care not to lock it. Lift up the seat barrel and seat cushion, then pull out and disconnect the seat cushion connecting wire, then take out the seat barrel and seat cushion Disconnect the wire harnesses, Clamp nut M3 with pointed nose pliers, lift the cover and remove 2 screws M510 with 2.7mm pentagonal bit, then take off the terminal outwards. Part 2: Assembly Install the charging terminal, pass the wires through the seat barrel coaming. After installation in place, Clamp nut M3 with pointed nose pliers, tighten two screws M3 * 10 with 2.7mm pentagonal bit, Torque: 0.9-1.1N·m. Then connect the wire harnesses. Place the seat barrel and seat cushion assembly on the vehicle body, and connect the cushion cable. Then, install the seat barrel, fasten four pentagonal pan head screws M616 with 5.45mm inner Pentagon anti-theft bit, Torque: 9.8-14N·M. then close and lock the seat cushion.