Segway Max Pro (2.2) Electric Scooter - Rear Light Repair Video

How to replace the rear fender and the rear light?Tool preparation Torque screwdriver, T20, H3, PH1, tweezers, new rear foot pad, new fender and new tail light. Remove the cover of the tail light wire. Lay down the scooter, remove 2 screws M414 with T20, take off the cover and disconnect the tail light wire. Remove the rear fender assembly. Lift the scooter. Remove the rear foot pad, remove 4 cross pan head screws M48 with H3, then take off the rear fender assembly. Remove the protective plate Remove 2 cross recessed countersunk head screws ST2.96.5 and 2 cross half round head flat tail self-tapping carbon steel galvanized screws ST2.99.5 with PH1, then take off the protective plate. Remove the tail light Remove 2 cross half round head flat tail self-tapping carbon steel galvanized screws ST2.99.5 with PH1, take off the terminal adapter with tweezers. Remove 2 cross half round head tapping screws ST2.96.5 with PH1, then pull out wire harness and take out the tail light. Install new tail light Straighten the wire harness through the hole of the fender, fasten 2 cross half round head tapping screws ST2.96.5 with PH1, Torque: 0.4±0.08N·m. Pass the terminal adapter through the tail lamp terminal, the groove of the adapter corresponds to the green step of the terminal, the convex groove towards the inside. Then fasten 2 cross half round head flat tail self-tapping carbon steel galvanized screws ST2.9 * 9.5 with Ph1(P17), Torque: 0.4±0.08N·m Install the protective plate Install the protective plate in place, Fasten 2 cross recessed countersunk head screw ST2.96.5 and 2 cross half round head flat tail self-tapping carbon steel galvanized screws ST2.9*9.5 with PH1, Torque: 0.4±0.08N·m. Install the rear fender assembly fasten 4 Hexagon socket head flat washer blue white zinc plated combination screws with H3, Torque: 2±0.2N·m, install the new rear foot pad. Install the cover of the tail light wire Push down the scooter. connect the tail light wire, fasten 2 screws with T20, Torque: 1.5±0.2N·m, then lift the scooter Function detection Power on the scooter, and confirm that it functions properly