Segway S90L Electric Scooter - Taillight Repair Video

How to replace the taillight Remove the rear fender Lay down the scooter and remove 2 screws M414 with T20, remove the rear light cover. disconnect the rear light terminal. Straighten the vehicle, remove the rear footpad, remove the 6 M412 screws with the T20 head, and remove the rear fender assembly. Remove the taillight Using PH2 cross batch head, remove the 6 cross recessed pan head screws and remove the wire protection plate. Using PH2 cross batcher, remove terminal adapter locking screw. Use tweezers to separate the taillight white terminal from the adapter groove, and take out the rear taillight wiring harness through the corresponding hole in the fender. Install the taillight Take out a new tail lamp line, wire first stroke straight through the fender corresponding hole location, then tail lamp according to the contour outline into fender hole, on the screw holes, pay attention to the wire and tail light white terminal steps of transfer alignment grooves, will harness, concentrated in the slots using PH2 cross group of head lock terminal adapter, Load the wire guard plate into the rear fender, align the hole position, lock 6 cross groove tapping screws, torque 0.45-0.55n.m. Install the rear fender Take a new rear fender assembly and use T20 to lock it with 6 inner hexagon stainless steel M412 screws with a torque of 2± 0.2n.m. Attach the rear footpad. Put the vehicle upside down, insert taillight terminal wire, install rear taillight cable cover plate, tighten 2 screws M412 with T20 head, torque 1.5± 0.2n.m.