Segway S90L Electric Scooter - Left Brake Handle Assembly Repair Video

Use T10 bits to remove the 8 screws (P1) on the lower cover of the decorative cover and remove the lower cover.

Loosen the fixing screw on the left brake handle with T30 bit (P2); Remove the left brake handle assembly, hold the brake handle, remove the brake cable end from the claw with needle-nose pliers (P3), remove the brake cable end from the round hole of the brake handle, disconnect the connection cable between the brake handle assembly and dash board assembly (P4), and remove the left brake handle assembly.

Take the new left brake handle assembly and connect the brake handle cable to the cable of the dashboard assembly (P5); Grip the brake handle to expose the claw, put the brake cable end into the round hole of the brake handle and expose it from the claw (P6), and put thebrake cable end into the claw (P7) with needle-nose pliers. The brake line is installed in the brake handle slot, the metal of the brake line sleeve is pressed against the steps in the brake handle slot, and the brake handle assembly is buckled on the handlebar. Pay attention to the wiring harness, to prevent being squeezed by the brake handle. Fasten M6 anti-theft screw of brake handle assembly with T30 bit, torque 7-9N·m(P8).

Take the lower cover of the decorative cover, install it according to the corresponding hole position, use T10 bit to lock the corresponding 8 screws (P9), and complete the replacement of the left brake handle assembly.