Segway L60E Electric Scooter - Electronic Lock Repair Video

Use APP to open the battery compartment cover and remove the battery; Remove the rubber pad from the rear fender (P1) and use the T20 batch head to remove the 4 screws holding the cover plate in the control area (P2) and remove the cover plate; Remove the 6 screws holding the rear fender assembly (P3) using a T20 batch head.

Remove the three screws holding the battery lock (P4) using the T20 batch head, pull out the battery lock wiring harness, disconnect the battery lock (P5), and remove the battery lock.

Take the new battery lock, pass the wiring harness through the bottom hole of the battery bin (P6), and connect the battery lock wiring harness to the controller (P7).

4, 使用 T20 批头锁紧固定电池锁的 3 颗螺钉(P8), 螺钉上点红色耐落胶, 螺钉尾部3-5牙, 至少180°, 扭力 1.3±0.2N·m; 将电池线束放置到电池仓槽内, 使用 T20 批头锁紧后挡泥板总成的 6 颗螺钉(P9), 扭力 1.5±0.2N·m; 取控制区域盖板, 使用 T20 批头锁紧固定盖板的 4 颗螺钉(P10), 扭力 1.3±0.2N·m. Use T20 batch head locking to fasten the three screws (P8) fixing the battery lock, with red glue on the screws, 3-5 teeth at the tail of the screws, at least 180°, and torque 1.3±0.2N·m; Place the battery harness in the battery compartment and use the T20 batch head to lock the 6 screws (P9) of the rear fender assembly with a torque of 1.5±0.2N·m; Take the cover plate of the control area and use the T20 batch head to lock the four screws (P10) fixing the cover plate with a torque of 1.3±0.2N·m.