Segway E110L E-Moped - Side Kickstand And Switch Repair Video

How to the side kickstand and the switch

Tool preparation: tweezers, PH2 bit, 3.95mm pentagonal bit, 5.45mm pentagonal bit, 17mm wrench, cross screwdriver, electric screwdriver Part 1: disassembly Press down and eject the left foot rest, remove 1 screw M6 * 12 with 5.45mm pentagonal bit, remove the left foot rest trim, and then fold up the left foot rest. Remove one screw ST4.214 with PH2 bit. Remove the 1 screw ST4.212 at the end of the left middle edge strip with 3.95mm pentagonal bit. Remove 2 rubber stoppers on left side of the pedal, then remove 2 screws ST4.212 with 3.95mm pentagonal bit. Remove the 3 screws ST4.212 under the left middle edge strip with 3.95mm pentagonal bit, and then remove the left middle edge strip and trim assembly. Take the harness out of the buckle and disconnect the harness, remove 1 screw M616 with PH2 bit and take out the switch. Remove the bolt M1022.5 with 17mm wrench, then take out the spring and the side kickstand. Part 2: assembly Install the kickstand with the end with the lug facing out, Insert the bolt M1022.5 from the outside, fasten it with 17mm wrench, Torque: 20-30N·M Install the spring, hang the long end of the spring arm to the corresponding position of the frame, then hang the other end of the spring onto the side support lug with a screwdriver Install the switch, fasten 1 screw M616 with PH2 bit, Torque: 7-11N·m. Connect the wire harness and fix it with the wire clip Install the left side middle edge strip, and fasten 2 screws st4.212 on the strip with 3.95mm pentagonal bit, Torque: 1.9-2.7N·m. Then tighten one cross screw st4.212 with PH2 bit, Torque: 1.9-2.7N·m. Fasten 4 screws st4.212 under the strip with 3.95mm pentagonal bit, Torque: 1.9-2.7N·m. Pop out the left foot rest, install the left foot rest trim, and fasten one screw M612 with 5.45mm Pentagram bit, Torque: 7-11N·m Install 2 rubber plugs

Prev: No Data ...