Segway E110L E-Moped - Iot Assembly Repair Video

How to replace the IOT assembly

Tool preparation: tweezers, PH2 bit, 3.95mm pentagonal bit, new IOT assembly. Part 1: disassembly Power off the moped. Remove 2 rubber stopper, then remove 2 screws ST4.212 with 3.95mm pentagonal bit, then slap the connection between the panel and the front windshield, and take out the panel Disconnect the wire harness of the IOT assembly, the remove 2 screws ST4.212 with PH2 bit, and then remove the IOT assembly. Part 2: assembly Install the IOT assembly, fasten 2 screws ST4.212 with PH2 bit, Torque: 1.9-2.7N·m, then connect the wire harness. Install the panel, buckle it to the front windshield, and fasten 2 screws ST4.212 with 3.95mm pentagonal bit, Torque: 1.9-2.7N·M, and then install the rubber stopper

Prev: No Data ...