Segway C80 E-Moped - Usb Terminal Repair Video

How to replace the USB terminal

Tool preparation:3.95mm pentagonal bit, flat screwdriver, Electric screwdriver Part 1: disassembly Pull out the panel along the edge with force. Remove 4 pentagonal screws ST4.212 with 3.95mm pentagonal bit, then pull out the cowl panel with force. Disconnect the wire harness of the USB terminal: red, black - brown black. Press the buttons on both sides of the USB with a flat screwdriver and push outwards, take out the USB terminal. Part 2: assembly Install the back cover buckle onto the USB body. Insert the wire harness from the round hole of the front windshield, and fully install it. Pay attention to the USB port direction, transverse direction, and the three-way arrow facing left, then connect USB wire harness Attach the edge panel to the frame, Pay attention to the alignment of the clip slot. Then fasten 4 pentagonal screws ST4.212 with 3.95mm pentagonal bit, and Torque: 1.9-2.7N·m. Install the front plate, and align to the clamping slot and make it fully engaged.