Segway C80 E-Moped - Stem Lock Repair Video

How to replace the stem lock

Tool preparation: 3.95mm pentagonal bit, PH1 bit, PH2 bit, , Electric screwdriver Part 1: disassembly Pull out the panel along the edge with force. Remove 4 pentagonal screws ST4.212 with 3.95mm pentagonal bit, then pull out the cowl panel with force. Remove the screws ST4.212 on both sides of the front inner fender and take out the fender. Disconnect the harness of stem lock, 5pin wire: red, yellow, blue, purple, black - purple white, green white, gray white, yellow gray, yellow powder, remove 2 screws M616 with PH2 bit, and take out the stem lock Remove the cover plate, take out 2 screws M2.58 with PH1 bit, take down the fixing piece, and take out the stem lock assembly. Part 2: assembly Install the wire on the stem lock, install the fixing piece and fasten two M2.58 screws with PH1 bit, Torque: 0.8-1.2N·m, and install the cover plate. Install stem lock, pay attention to the position of lock body, the end with wire harness is at the bottom, align with screw hole, and fasten two screws M616 with PH2 bit, Torque: 7-11N·m. pay attention to lock the wire clamp together when locking the screw under the lock. Connect the harness of stem lock. Install the front inner fender, align the clips on both sides with the slots, and press in. fasten the screws on both sides with PH2 bit, Torque: 1.9-2.7N·m. Attach the edge panel to the frame, Pay attention to the alignment of the clip slot. Then fasten 4 pentagonal screws ST4.2*12 with 3.95mm pentagonal bit, and Torque: 1.9-2.7N·m. Install the front plate, and align to the clamping slot and make it fully engaged.