Segway C80 E-Moped - Cowl Panel And Front Inner Fender Repair Video

How to replace the cowl panel and front inner fender

Tool preparation: 3.95mm pentagonal bit, PH2 bit, Tweezers, Electric screwdriver Part 1: disassembly Pull out the panel along the edge with force. Remove 4 pentagonal screws ST4.212 with 3.95mm pentagonal bit, then pull out the cowl panel with force. Remove the screws ST4.212 on both sides of the front inner fender and take out the fender. Remove 4 clips with the tweezers on the front panel, then push the logo out. Remove 2 self-tapping clips st4.2 and 2 clips with the tweezers on the front inner fender. Remove 2 self-tapping clips st4.2 and 2 clips with the tweezers on the cowl panel. Part 2: assembly Take the new logo, install it on the front panel, pay attention to direction of the logo and press it into place. Then install 4 clips. Install 2 self-tapping clips st4.2 and 2 clips on the front inner fender. Install 2 self-tapping clips st4.2 and 2 clips on the cowl panel. Note that the flat end of the self-tapping clip is facing outward and the protruding end is facing inward Install the front inner fender, align the clips on both sides with the slots, and press in. fasten the screws on both sides with PH2 bit, Torque: 1.9-2.7N·m. Attach the edge panel to the frame, Pay attention to the alignment of the clip slot. Then fasten 4 pentagonal screws ST4.2*12 with 3.95mm pentagonal bit, and Torque: 1.9-2.7N·m. Install the front plate, and align to the clamping slot and make it fully engaged