Segway E110L E-Moped - Front Cover Of The Handlebar Repair Video

How to replace the front cover of the handlebar

Tool preparation: PH2 bit, tweezers, 3.95mm pentagonal bit, 5.45mm pentagonal bit, electric screwdriver Remove the rearview mirror Power off the moped, remove 1 screw M830 with 5.45mm Pentagonal bit, then take out the left rearview mirror. And remove the right rearview mirror in the same way. Remove the front cover of the handlebar Remove 4 screws ST4.212 on the bottom of the handlebar cover with 3.95mm pentagonal bit, hold the front cover and knock down the joint of the front and rear covers with the fist, then take out the front cover. Remove 2 screws M610 with 5.45 mm pentagonal bit and take out the front windshield of the dashboard. Remove 4 ST4.2 clips on the cover. Remove 2 screws ST.212 with PH2 bit, and take out the base Then remove the clasp with the tweezers Part 2: Assembly Install the front cover of the handlebar Take the front cover, install the base on it, install 2 screws ST.212 with PH2 bit, Torque: 1.9-2.7N·m. Install the clasp and four ST4.2 clips with the smooth end facing out on the cover. Install the front windshield of the dashboard on the base, fasten 2 screws M610 with 5.45 mm pentagonal bit, Torque: 7-11N·m. Install the front cover onto the handlebar, clasp together with the rear cover, and then fasten four screws st4.212 with a 3.95mm bit. The torque is 1.9-2.7N·m Install rearview mirror Install the left rearview mirror on the handlebar, Align the screw holes, install the bolt M830, and fasten it with 5.45mm Pentagonal bit, Torque: 22-30N·M, then install the right rearview mirror in the same way.