Segway C80 E-Moped - Kickstand Switch Repair Video

How to replace the switch of the side kickstand

Tool preparation: 3.95mm pentagonal bit, 5.45mm mm pentagonal bit, H4 bit, PH2 bit, oblique pliers, Cable tie, Electric screwdriver Part 1: disassembly Pull out the panel along the edge with force. Remove 4 pentagonal screws ST4.212 with 3.95mm pentagonal bit, then pull out the cowl panel with force. Remove the screws ST4.212 on both sides of the front inner fender and take out the fender. Press down on the edge strip, and separate the middle edge strip and pedal on both sides with force outwards. Remove 4 screws M612 on the foot pedal with 5.45mm pentagonal bit. Press and hold the bucket coaming, lift up the rear of the foot pedal, and separate the two sides of the pedal and the bucket connection. Press and hold the front windshield, lift up the front of the pedal, separate the connection between the pedal and the front windshield, and take out the pedal backward. Cut off the cable tie, disconnect the terminal connection, and thread the switch harness out from under the main harness. Remove two M516 screws from the lower part of the frame with H4 bit and remove the switch. Part 2: assembly Take a new side kickstand switch, the end of the harness is on the right side, align with the screw hole, and fasten two M516 screws with H4 bit, Torque: 3.4-5N·m. Run the harness out from the bottom of the main harness and insert it in pairs, then tie the cable tie with the main harness Install the pedal, insert the pedal bayonet into the front windshield card slot, press the screw holes on both sides to fasten the foot pedal and the front windshield together. Align the screw holes, press the tail of both sides of the foot pedal, and install it with the seat barrel buckle. Tighten 4 screws M612 with 5.45mm pentagonal bit, Torque: 7-11N·m. Press the edge strip inward to make the edge strip on both sides and the foot pedal together. Install the front inner fender, align the clips on both sides with the slots, and press in. fasten the screws on both sides with PH2 bit, Torque: 1.9-2.7N·m. Attach the edge panel to the frame, Pay attention to the alignment of the clip slot. Then fasten 4 pentagonal screws ST4.2*12 with 3.95mm pentagonal bit, and Torque: 1.9-2.7N·m. Install the front plate, and align to the clamping slot and make it fully engaged.