Segway S90L Electric Scooter - Electronic Lock Repair Video

How to replace the electronic lock Remove the battery Use the software to open the e-lock and lift the pedal. Unplug the power and remove the battery. Remove the electronic lock Use T20 head to remove the four hex socket M48 stainless steel screws, remove the front plug cover, find the connection between the controller and the motor lock is disconnected. Use T30 batch head to remove 4 M612 screws from motor lock protection cover, and remove motor lock cover. Using PH2 head, remove the three M425 cross recessed countersunk head screws from the electronic lock, and then pull the electronic lock wire out of the threading hole at the lower right end of the electronic lock. Install the electronic lock Take a new electronic lock, thread the blue terminal wire of the electronic lock through the threading hole at the lower right end of the electronic lock, then lock three M425 cross recessed countersunk stainless steel screws with PH2 head, torque 1.5± 0.2n.m, install the baffle. Take the electronic lock protection cover, use T30 batch head to lock 4 M612 screws, torque 3.5-4.5n.m, install the front plug cover, use T20 to tighten the four M48 hex stainless steel screws, torque: 1.3-1.5N.M. Install the battery Put the battery in the compartment, lift the power plug of the controller end to avoid being crushed by the battery, plug in the power plug, and ensure that the plug is fully inserted; Cover foot pedal.

Prev: No Data ...