Segway S90L Electric Scooter - Vertical Tube Repair Video

1, 拆下IOT(P1), 参考S90L-C002更换IOT SOP Remove the IOT(P1) and replace the IOT SOP by referring to S90L-C002 Remove stem assembly (P2) and replace stem assembly SOP by referring to S90L-C001

Use T30 batch head to remove 1 screw on vertical tube M620(P3); Move vertical tube jacket upward (P4). Remove 3 screws M720(P5) with T30 batch head and lift vertical tube (P6, P7)

Installation of the vertical tube: take the vertical tube sheath, long side down from the lower end of the vertical tube into the upper (P8), the frame head tube out of the central control harness and brake line from the bottom of the vertical tube into the jacket(P9), move the jacket upward, slightly rotate the jacket to avoid the vertical tube screw hole; Confirm that the hole of the vertical tube is aligned with the hole of the vertical tube adapter, lock the hole of the vertical tube adapter (P10) with one M620 inner hexagon flower screw, and then lock the three special screws for concealed line vertical tube (P11) with a torque of 12-14N.M. Remove the M620 screws that have just been pre-tightened at the front end, and put the vertical tube protection set in place so that the holes on it and the adapter. Align the holes in the vertical tube and secure the vertical tube with one M6*20 screw (P12) without loosening or shaking.

Install the stem assembly and replace the stem assembly SOP by referring to S90L-C001 Install IOT, refer to S90L-C002 to replace IOT SOP, and complete the replace of vertical tube.

Prev: No Data ...