Segway E110L E-Moped - Usb Terminal Repair Video

How to replace the USB terminal

Tool preparation: tweezers, PH2 bit, 3.95mm pentagonal bit, new USB terminal Part 1: disassembly Power off the moped. Remove 2 rubber stopper, then remove 2 screws ST4.212 with 3.95mm pentagonal bit, then slap the connection between the panel and the front windshield, and take out the panel Disconnect the USB wire, against the buckle on both sides of the USB terminal, then take out USB terminal Part 2: assembly Install the new USB terminal, Pass the wire harness through the front windshield from the storage box. The Trident arrow should face left, and the clips on both sides should be completely exposed, then connect the USB wire. Install the panel, buckle it to the front windshield, and fasten 2 screws ST4.212 with 3.95mm pentagonal bit, Torque: 1.9-2.7N·M, and then install the rubber stopper.