Segway C80 E-Moped - Iot Assembly Repair Video

How to replace the IOT assembly

Tool preparation: 3.95mm pentagonal bit, PH2 bit, Corner device, Electric screwdriver Part 1: disassembly Pull out the panel along the edge with force. Remove 4 pentagonal screws ST4.212 with 3.95mm pentagonal bit, then pull out the cowl panel with force. Remove the screws ST4.212 on both sides of the front inner fender and take out the fender. Disconnect the wire harness of the IOT assembly, the remove 2 screws M616 with PH2 bit and corner device, and then remove the IOT assembly. Part 2: assembly Install the IOT assembly, fasten 2 screws M616 with PH2 bit and corner device, Torque: 7-11N·m, then connect the wire harness. Install the front inner fender, align the clips on both sides with the slots, and press in. fasten the screws on both sides with PH2 bit, Torque: 1.9-2.7N·m. Attach the edge panel to the frame, Pay attention to the alignment of the clip slot. Then fasten 4 pentagonal screws ST4.2*12 with 3.95mm pentagonal bit, and Torque: 1.9-2.7N·m. Install the front plate, and align to the clamping slot and make it fully engaged.