Segway B100 E-Bike - Taillight Repair Video

Remove the decorative cover labels (P1) on both sides of the rear fender, and use T20 batch head to remove the four screws fixing the decorative cover respectively (P2).

Use T20 batch head to remove 6 screws holding rear fender (P3, P4, P5), pull out rear fender and disconnect taillight harness connection wire (P6)

Use PH1 batch head to loosen the 3 screws (P7, P8, P9) securing the cover of the taillight wire, remove the cover of the taillight wire harness, remove the taillight wire harness from the buckle and pull out the taillight wire harness (P10, P11)

Take the new taillight, push the wire harness of the rear taillight straight through the corresponding hole of the fender (P12), then plug the rear taillight into the hole of the fender according to the contour of the profile, and clamp the two buckle of the rear taillight into the corresponding hole of the rear fender (P13), pull the taillight wire harness along the groove of the mud plate to the front hole of the fender, and take three cross-grooved disc head tapping screws. Tighten the taillight wire harness cover plate with PH1 batch head, torsion force: 0.3±0.1N·m.

Take the complete rear fender assembly, butt the taillight wiring harness with the taillight extension wire at the rear of the battery compartment (P14), align the rear fender assembly with the threaded hole of the frame, use T20 batch head lock the 6 screws (P15, P16, P17) to fix the rear fender, torque: 1.1±0.1N·m; Take the left and right rear decorative covers and install them on the rear axle of the frame. The notch of the decorative covers faces back, and the screw holes are aimed at the frame holes. Use T20 head to fix the screws (P18) on both sides, and the torsion force is 1.1±0.1N·m. Take the rear fork decoration label (P19) and attach it to the groove of the decoration cover. The stickers should be flat, without bubbles, warped edges, creases or scratches.

Prev: No Data ...